A practical reference on CJC-1295: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2025-11-04. Anything still debated is marked as such rather than presented as settled.
Two related forms appear under the CJC-1295 name. The simpler analogue, commonly written as modified GRF(1-29), carries the four substitutions but no additional conjugation. The second form attaches a maleimidopropionic acid linker to a lysine residue, a modification frequently called the drug affinity complex. That linker reacts with the free thiol on serum albumin to form a covalent bond. Because albumin has a long residence time in blood, the conjugated peptide stays in circulation far longer than the unconjugated analogue.
Receptor level activity follows the canonical GHRH pathway. The peptide binds the GHRH receptor, a class B G protein coupled receptor on somatotroph cells of the anterior pituitary. Binding raises intracellular cyclic AMP, which promotes calcium entry and the release of growth hormone into the bloodstream. Because the molecule acts at the same receptor as the endogenous hormone, its effect is superimposed on the natural pulsatile rhythm rather than replacing it. Whether sustained receptor occupation leads to desensitization is not fully settled.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
| Property | Value | Notes |
|---|---|---|
| Peptide class | Synthetic GHRH analogue | Built on a 29 residue sequence |
| Primary target | GHRH receptor (GHRHR) | Class B G protein coupled receptor |
| Unconjugated half life | Minutes | Limited by protease degradation |
| Key modification | Four residue substitutions | Positions 2, 8, 15 and 27 |
| Common synonym | Modified GRF(1-29) | Usually denotes the form without DAC |
CJC-1295 is a synthetic peptide belonging to the growth hormone-releasing hormone analog family. It comprises twenty-nine amino acid residues derived from the N-terminal region of natural GHRH. The molecule incorporates several non-natural substitutions that increase resistance to enzymatic degradation. These modifications extend its activity compared with the native hormone fragment. Researchers use it to study pituitary growth hormone secretion in laboratory and clinical settings. This compound is distinct from native GHRH in its stability profile.
Two principal forms appear in the literature and in research supply. One carries a drug affinity complex, a maleimide-based group that forms a covalent bond with circulating albumin. This linkage slows clearance and produces a long-lasting elevation of peptide levels. The other form lacks that group and is often labeled MOD GRF(1-29). It has a much shorter circulation time. Both variants retain the same core receptor-binding sequence. Reported half-lives differ substantially between the two.
At the pituitary, the peptide binds the growth hormone-releasing hormone receptor on somatotroph cells. Receptor activation raises intracellular cyclic AMP and triggers release of stored growth hormone. Somatostatin and other hypothalamic signals modulate this response. Negative feedback from insulin-like growth factor 1 also influences output. The same regulatory architecture operates with the native hormone. Whether the synthetic analog alters feedback dynamics over repeated exposure remains an open question. Most published receptor work uses cell models rather than intact human systems.
Lyophilized material is typically stored at minus twenty degrees Celsius or lower. Keeping the vial dry and protected from light preserves peptide integrity. Repeated freeze-thaw cycles can cause aggregation or loss of activity. Once dissolved, solutions are generally kept at two to eight degrees Celsius. Stability data for reconstituted solutions vary, and long-term behavior is not fully established. Working aliquots reduce the number of times a stock container is opened.
Reverse-phase high-performance liquid chromatography is the standard tool for purity assessment. The technique separates the target peptide from truncated or modified byproducts. Mass spectrometry confirms molecular weight and supports sequence verification. Electrospray ionization and matrix-assisted laser desorption are both used. Amino acid analysis provides an independent check on composition. Purity values are commonly reported as area percentage from the chromatogram. Residual trifluoroacetate and water content are also measured in many quality programs.
Although a rate law provides the stoichiometry of the transition state structure, it does not provide any information about breaking or forming bonds. The substitution of an isotope near a reactive position often leads to a change in the rate of a reaction. Isotopic substitution changes the potential energy of reaction intermediates and transition states because heavier isotopes form stronger bonds with other atoms. Atomic mass affects the zero-point vibrational state of the associated molecules, shorter and stronger bonds in molecules with heavier isotopes and longer, weaker bonds in molecules with light isotopes. Because vibrational motions will often change during a course of a reaction, due to the making and breaking of bonds, the frequencies will be affected, and the substitution of an isotope can provide insight into the reaction mechanism and rate law.
Dry ice is the solid form of carbon dioxide (CO2), a molecule consisting of a single carbon atom bonded to two oxygen atoms. Dry ice is colorless, odorless, and non-flammable, and can lower the pH of a solution when dissolved in water, forming carbonic acid (H2CO3). At pressures below 5.13 atm and temperatures below −56.4 °C (216.8 K; −69.5 °F) (the triple point), CO2 changes from a solid to a gas with no intervening liquid form, through a process called sublimation. The opposite process is called deposition, where CO2 changes from the gas to solid phase (dry ice). At atmospheric pressure, sublimation/deposition occurs at 194.7 K (−78.5 °C; −109.2 °F). The density of dry ice increases with decreasing temperature and ranges between about 1.55 and 1.7 g/cm3 (97 and 106 lb/cu ft) below 195 K (−78 °C; −109 °F). The low temperature and direct sublimation to a gas makes dry ice an effective coolant, since it is colder than water ice and leaves no residue as it changes state. Its enthalpy of sublimation is 571 kJ/kg (25.2 kJ/mol, 136.5 calorie/g). Dry ice is non-polar, with a dipole moment of zero, so attractive intermolecular van der Waals forces operate. The composition results in low thermal and electrical conductivity.
Mexico's participation in World War II had its first antecedent in the diplomatic efforts made by the government before the League of Nations as a result of the Second Italo-Ethiopian War. However, this intensified with the sinking of oil tankers by German submarine attacks, resulting in Mexico declaring war on the Axis powers of Nazi Germany, Fascist Italy, and the Empire of Japan in May 1942. World War II had a profound influence on the country's politics and economy. Unlike most nations involved, the economic effects of the war were largely positive for Mexico.
Sources: en.wikipedia.org
In 1842, John Gorrie created a system capable of refrigerating water to produce ice. Although it was a commercial failure, it inspired scientists and inventors around the world. France's Ferdinand Carre was one of the inspired and he created an ice producing system that was simpler and smaller than that of Gorrie. During the Civil War, cities such as New Orleans could no longer get ice from New England via the coastal ice trade. Carre's refrigeration system became the solution to New Orleans' ice problems and, by 1865, the city had three of Carre's machines. In 1867, in San Antonio, Texas, a French immigrant named Andrew Muhl built an ice-making machine to help service the expanding beef industry before moving it to Waco in 1871. In 1873, the patent for this machine was contracted by the Columbus Iron Works, a company acquired by the W.C. Bradley Co., which went on to produce the first commercial ice-makers in the United States. By the 1870s, breweries had become the largest users of harvested ice. Though the ice-harvesting industry had grown immensely by the turn of the 20th century, pollution and sewage had begun to creep into natural ice, making it a problem in the metropolitan suburbs. Eventually, breweries began to complain of tainted ice. Public concern for the purity of water, from which ice was formed, began to increase in the early 1900s with the rise of germ theory. Numerous media outlets published articles connecting diseases such as typhoid fever with natural ice consumption. This caused ice harvesting to become illegal in certain areas of the country.
Bacalhau is the Portuguese word for codfish and in a culinary context refers to dried and salted codfish. Fresh (unsalted) cod is referred to as bacalhau fresco (fresh cod). Bacalhau dishes are common in Portugal and Galicia, in the northwest of Spain, and to a lesser extent in former Portuguese colonies like Angola, Macau, and Brazil. There are said to be over 1000 recipes in Portugal alone and it can be considered the iconic ingredient of Portuguese cuisine (yet the only fish that is not consumed fresh in this fish-loving nation). It is often cooked on social occasions and is the Portuguese traditional Christmas dinner in some parts of the country. Baccalà (bacalà in the Venetian language) is sun-dried stockfish, rather than salt cod. In other parts of Italy, dishes made with salt cod are given the same name. Baccalà dishes made with stockfish are soaked for several days to soften the fish. Salt cod, which is already soft, is also soaked to remove excess salt. Balyk is the Russian term for the salted and dried soft parts of fish of large valuable species, such as sturgeon or salmon. Over time, the term has come to apply also to smoked fish of these species. Boknafisk is a variant of stockfish and is unsalted fish partially dried by sun and wind on drying flakes or on a wall. The most common fish used for boknafisk is cod, but other types of fish can also be used. If herring is used, the dish is called boknasild. Bugeo refers to dried Alaska pollock. Daing (also known as bulad or tuyô) refers to sun-dried fish in the Philippines.
UVA can generate highly reactive chemical intermediates, such as hydroxyl and oxygen radicals, which in turn can damage DNA. The DNA damage caused indirectly to skin by UVA consists mostly of single-strand breaks in DNA, while the damage caused by UVB includes direct formation of thymine dimers or cytosine dimers and double-strand DNA breakage. UVA is immunosuppressive for the entire body (accounting for a large part of the immunosuppressive effects of sunlight exposure), and is mutagenic for basal cell keratinocytes in skin. UVB photons can cause direct DNA damage. UVB radiation excites DNA molecules in skin cells, causing aberrant covalent bonds to form between adjacent pyrimidine bases, producing a dimer. Most UV-induced pyrimidine dimers in DNA are removed by the process known as nucleotide excision repair that employs about 30 different proteins. Those pyrimidine dimers that escape this repair process can induce a form of programmed cell death (apoptosis) or can cause DNA replication errors leading to mutation. UVB damages mRNA This triggers a fast pathway that leads to inflammation of the skin and sunburn. mRNA damage initially triggers a response in ribosomes though a protein known as ZAK-alpha in a ribotoxic stress response. This response acts as a cell surveillance system. Following this detection of RNA damage leads to inflammatory signaling and recruitment of immune cells. This, not DNA damage (which is slower to detect) results in UVB skin inflammation and acute sunburn.
Sources: en.wikipedia.org
The names are often used interchangeably in casual writing, but they are not strictly identical. Modified GRF(1-29) refers to the unconjugated analogue carrying only the four substitutions. The version sold as CJC-1295 with DAC includes the albumin binding linker and clears much more slowly.
DAC stands for drug affinity complex, a term describing the maleimidopropionic acid linker. This group forms a covalent bond with the cysteine residue on serum albumin after administration. The resulting adduct is what extends the circulating half life from minutes to days.
No. It is entirely synthetic and does not correspond to any known endogenous peptide. The design starts from human growth hormone releasing hormone and introduces deliberate substitutions. Any biological effect comes from mimicking the natural hormone at its receptor.
The mass difference from the linker is large enough for routine detection by mass spectrometry. The unconjugated form gives a single sharp signal at its expected weight. Material that has already reacted with albumin shows a much higher mass and a broadened chromatographic peak.